Challenger MT455E, MT465E, MT475E Tractor Service Manual Workshop Guide

Challenger MT455E, MT465E, MT475E Tractor Workshop Manual : 1376 Pages Technician Service Book MT400E (Schematics and Electronics) : 646 Pages Spicer Dana 740, 735 Axle Service Manual: 176 Pages & 176 Pages Description Challenger MT455E, MT465E, MT475E Tractor Repair Workshop Manual Manual for: AGCO Challenger MT400E Series Tractor Format: PDF Book Number: ACT0026660 English Issued May 2016 Challenger MT455E, MT465E, MT475E Tractor Workshop Manual : 1376 Pages Technician Service Book MT400E (Schematics and Electronics) : 646 Pages Spicer Dana 740, 735 Axle Service Manual: 176 Pages & 176 Pages Challenger MT400E Series Manual TABLE OF CONTENTS Introduction Separation of assemblies Engine Clutch Gearbox Rear Axle Power Take off Front Axle Hydraulics Electricity Electronics Operator Environment Accessories Services Tools MT455E, MT465E, MT475E Manual Error Code Err 14 See error message 17/18 Err 15 The maximum front or rear transmission ratio has not been reached. Repeat Repeat calibration. If nec If necessary, check the efficiency of the hydrostatic system. Err 50 Calibration is interrupted by the user with the Err 51 Speed is above 0,1 km/h Err 52 The engine speed is lower than 1400 rpm. Err 53 The hand brake is not applied. Err 54 The signal from the X8 – Bevel gear theoretical speed sensor is incorrect. Err 55 The signal from the X8 – Bevel gear theoretical speed sensor is incorrect. Err 56 The signal from the X25 – Engine speed sensor is incorrect. Err 57 Clutch pedal sensor: The pedal is not pressed. Err 58 Clutch pedal sensor is faulty. Err 59 High/low speed range (Hare/Tortoise) shift switch has been activated. Err 60 High/low speed range (Hare/Tortoise) shift switch is faulty. Err 61 High/low speed range (Hare/Tortoise) shift switch has been activated. Err 62 High/low speed range (Hare/Tortoise) shift switch is faulty. Err 63 The range position sensor is not in neutral due to the calibration of the range position sensor. Err 64 Electrical fault with X11 – Solenoid valve limiting speed to 30 km/h